shielded contacts b-31 glenair, inc. ? 1211 air way ? glendale, ca 91201-2497 ? 818-247-6000 ? fax 818-500-9912 ? 2012 glenair, inc. printed in u.s.a. cage code 06324 www.glenair.com e-mail: sales@glenair.com b AI85015 twinax pin contact assembly instructions step 1 1. strip cable to dimensions shown. be careful not to fare braid open . 2. pre-tin conductor and braid shield. 3. clean the solder joint with alcohol. .150 (3.81) .102 (2.60) conductors dielectric .250 (6.40) cable shield step 2 1. insert cable into pin contact. make sure center conductor lines up to the center pin. step 3 1. install center conductors until they bottom-out in the contact cavity. inspect to ensure cable shield is visible through the inspection hole . 2. apply fux and solder through the inspection hole; remove residues and contamination with alcohol after soldering. step 4 1. install m23053/5-204 or m23053/6-204 shrink tubing; cover solder area and extend insulation by minimum of one wire diameter. shrink tubing step 5 1. illustrates fnal assembly. pin contact 100 ohm parallel cable
|