pg-35h pressure gauges for high pressure for corrosive gases and liquids compatible with sus316l stainless steel diaphragm low consumption by nondisplay mode features ? ? ? ? ? ? ? ? ? ? part name material adaptor push cable sensor holder diaphragm m4 screw push nut plug fitting shield case 1 2 3 6 7 8 9 5 4 ! 0 pbt (polybutyleneterephthalate) vinyl chlorid resin aluminum sus316l sus316l sus303 (r2 only) spring steel (r2 only) sus303 (r2 only) 3 iron, nickel ( sus316 panel sheet polyester internal structure (r 1/4) model number designation p g - 3 5 h - 1 0 4 r - n r 2 series name pressure range 104 ? 0.1 ~ 10 mpa 354 ? 0.1 ~ 35 mpa pressure reference r compound pressure (negative pressure ~ positive pressure) fitting r2 r 1/4 g3 g 3/8 switch output interface n npn open collector p pnp open collector list of model numbers fitting switch output interface rated pressure range pressure reference gauge ? 0.1 ~ 10 mpa ? 0.1 ~ 35 mpa pg-35h-104r-nr2 pg-35h-354r-nr2 a pg-35h-104r-pr2 a pg-35h-354r-pr2 pg-35h-104r-ng3 pg-35h-354r-ng3 a pg-35h-104r-pg3 a pg-35h-354r-pg3 r2 (r 1/4) g3 (g 3/8) npn pnp npn pnp t verify the above model numbers when placing orders. marked a is manufactured upon receipt of order basis.
permissible change pg-35h pg-35h pressure gauges general specifications display switch output analog output item model number 104r 354r standard specifications pressure reference gauge corrosive hydraulic oil compatible with iron or nickel corrosive gases/liquids compatible with sus 316 and sus 316l ? 0.1 ~ 10 ? 0.1 ~ 35 20 50 40 50 ? 10 ~ 50 0 ~ 50 35 ~ 85 no condensation ip65 r 1/4, g 3/8 sus 316l approx. including 2 m cable 3 %f.s. (0 ~ 50 c) 100 m minimum 500 v ac 1 minute 10.8 ~ 30 v dc including ripple percentage 50 ma maximum full 3-digit led ? 0.10 ~ 9.99 ? 00.1 ~ 35.0 max. 11 settings approx. 4 times/s C led is on 2 % 2-point output (transistor, open collector output) separate mode / window comparator mode 30 v dc 100 ma maximum 1.2 v maximum (npn), 2.2 v maximum (pnp) output 1 (green led), y output 2 (red led) y lighted when output is on. 0 ~ 300 counts y adjustable 0.2 %f.s. 1 count approx. 5, 25, 250, 2500 ms y adjustable 3 modes 10 k 1/204 1 ~ 5 v r mode 104r-zero : 1.04 0.2 v, span : 3.96 0.2 v, 354r-zero : 1.01 0.2v, span : 3.99 0.2 v g mode zero : 1 0.2 v, span : 4 0.2 v t the accuracy at v mode is not guaranteed. npn/pnp pressure medium rated pressure range maximum pressure mpa mpa r2 g3 break-down pressure operating temp. range compensated temp. range operating humidity protection grade type of mounting material of pressure port attachment net weight g thermal error insulation resistance dielectric strength input voltage consumption current display element rated display range mpa multiplier settings display cycle negative pressure display display accuracy output status output mode switching capacity residual voltage state indication switch hysteresis repeatability response output mode output voltage v zero : pin=0, v span : pin=0 ? pin (h) impedance resolution ( ) mpa c c %rh unless otherwise specified, the specs are defined at an ambient temperature of 255 c and excitation voltage of 12 v dc. environmental characteristics test item test conditions pressure indication,switch operating points and analog output variation : 2 %f.s. maximum each after test vibration 10 ~ 500 hz, 98.1 m/s 2 or 1.5 mm p-p, 3 directions for 2 hours each 490 m/s 2 , 3 directions for 3 times each 0 ~ rated pressure z 10 6 cycles 40 c, 90 ~ 95 %rh, 240 hrs. shock pressure cycling moisture resistance
display multiplier selection code 1 1 0.0102 10.2 7.501 102 0.01 10 0.145 0.000145 0.001 0.2953 2 3 4 5 6 7 8 9 a b pressure range 1 s ? 1 s the last digit/letter represents the selection code : blinking red led indicates negative pressure. 104r 354r C 1.0 ~ 99.9 C 1 ~ 350 C 1.0 ~ 99.9 C 1 ~ 350 C 0.01 ~ 1.45 C 0.01 ~ 5.07 C 0.10 ~ 9.99 C 00.1 ~ 35.0 1 r mode 2 g mode display a.output shield load s.output1 main circuit power b sensor common s.output2 load 2 !y indicator 1 led pressure indication pressure a.output shield pressure indication sensor s.output1 s.output2 load pressure power b 1 2 led common load !y indicator main circuit internal electrical schematics selection of display multiplier analog output mode switch output mode 0 v u q v u . p e f 0 q f s b u j p o pressure setting (operating point) 4 f u u j o h 4 f u u j o h - p x f s m j n j u
|