pomona ? all dimensions are in inches. tolerances (except no ted): .xx = .02? (,51 mm), .xxx = .005? (,127 mm ). all specifications are to the latest revisions. spe cifications are subject to change without notice. registered trademarks are the property of their res pective companies. made in usa 10/1/07 www.pomonaelectronics.com d1094088 rev. 100 page 1 of 2 model 4233 with assembly instructions do-it-yourself micrograbber? & test clip kits sales: 800-490-2361 fax: 425-446-5844 technical support: technicalsupport@pomonatest.com features: ? ideal for connecting to small circuit board compone nts. ? use with model #?s 5173, 3690, 122505a or any other pomona ?do it yourself? product to create custom cables. ? supports 20 to 22 awg wire. materials: contact: beryllium copper, alloy 165 per qq-c-533, ? hm. spring: stainless steel, 302. finish: contact ? gold plated per mil-g-45204, type 1, class 00. insulation: glass filled nylon. markings: ?pomona?, ?grabber ? ?, ?4233?. ratings: operating temperature: +102 c (+216 f) max operating voltage: 150 vrms/dc current: 3 amperes ordering information: model 4233-* *=color, -0 black, -2 red, -9 white upon request, other colors can be quoted. ordering example: 4233-2 adapter color is red.
pomona ? all dimensions are in inches. tolerances (except no ted): .xx = .02? (,51 mm), .xxx = .005? (,127 mm ). all specifications are to the latest revisions. spe cifications are subject to change without notice. registered trademarks are the property of their res pective companies. made in usa 10/1/07 www.pomonaelectronics.com d1094088 rev. 100 page 2 of 2 model 4233 with assembly instructions do-it-yourself micrograbber? & test clip kits sales: 800-490-2361 fax: 425-446-5844 technical support: technicalsupport@pomonatest.com figure #1 a. remove the cap from housing assembly, the contact will now be exposed. b. insert the wire into the cap assembly allowing approximately 1 to 2 inches of wire to extend beyond the cap. c. strip wire 1/8 to 3/16 inches. d. insert exposed conductor through the hole in the contact and solder to surface. figure #2 e. important: solder must not extend beyond the indicated width. figure #3 f. install the cap onto the housing assembly. align the contact with the slots located on the cap.
|