features: wide operating temperature (-40c to 100c) stable threshold current for easy transmitter control (t0 ~ 80k) 1310 nm typical emission wavelength fp-ld?s metal lc package high-speed modulation capability (up to 4gb/s) excellent reliability ? ultra-low gradual wear-out rates ? <1% failures in 20 yrs at 55c application source for high-speed data-communication and telecommunication links ? sonet, fiber-channel, giag-bit ethernet, fttx 1310 nm fabry-perot (fp) laser diode lc package FP-1310-4I-LC preliminary data sheet the FP-1310-4I-LC is an mocvd grown inalgaas ridge laser diode with emission wave-length of 1310 nm and standard continuous light output of 5 mw. these lasers provide stable, single transverse mode oscillation. these are hermetically sealed devices in a coaxial package (to-56) with an integrated monitor photodiode to monitor the optical output. this is a suitable light source for data-com and telecom applications with data rates up to 4 gb/s. part number description FP-1310-4I-LC 1310 nm fabry-perot (fp) laser diode
FP-1310-4I-LC 1310 nm fabry-perot (fp) laser diode n otice: stresses greater than those listed under ?absolute maximum ratings? may cause permanent damage to the device. this is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time may affect reliability. absolute maximum ratings sy mbo l parameter c on d itions r atin g u nit p o output power cw 10 ma v r ld reverse voltage (laser diode) - 2 v v r pd reverse voltage (monitor photodiode) - 10 v i f pd forward current (photodiode) - 1 ma t c operation temperature - -40 to +100 c t stg storage temperature - -40 to +100 c
FP-1310-4I-LC electrical-optical characteristics symbol parameter test conditions minimum typical maximum unit i th threshold current cw 4 8 12 ma i thh threshold current at 100 c cw, t c =100c 16 21 30 ma t0 temperature dependence of threshold current - 80 - k i op operating current for p o = 5mw (cw) - 28 40 ma v op operating voltage cw voltage at i op - 1.15 1.25 v r op differential series resistance (laser diode) cw dv/di at t = 25 c between 15 ma and 25 ma 4 6 10 ? se slope efficiency 0.15 0.25 0.35 w/a ser se ratio 0.7 0.9 1 c lasing wavelength 1290 1310 1330 nm ? spectral width under modulation prbs 2^7-1 er =10 db; ib = 1.8*i th ; rms (sigma) - 1.5 2.75 nm d c /dt temperature dependence of lasing wavelength 0.40 0.45 0.55 nm/k t r rise time 20% - 80% ; t c = 85c; er = 10 db; ib = 1.8*i th - - 140 ps t f fall time 20% - 80% ; t c = 85c; er =10 db; ib = 1.8*i th - - 140 ps d droop t c = 85c; i = i th +36 ma; 0-6 ghz range -2 -1 - db f r relaxation oscillation frequency t c = 85c; i = i th +36 ma 5 5.5 - ghz c d capacitance for monitor photodiode - 50 - pf i mon monitor photodiode current 50 140 250 ma ? track tracking error -1.5 - +1.5 db i m0 dark current for monitor photodiode - - 0.1 ma unless otherwise stated, all parameters are at t case = 25c
FP-1310-4I-LC 1310 nm fabry-perot (fp) laser diode typical characteristics
FP-1310-4I-LC
FP-1310-4I-LC 1310 nm fabry-perot (fp) laser diode typical characteristics
FP-1310-4I-LC
pin out FP-1310-4I-LC 1310 nm fabry-perot (fp) laser diode pin hfe7192-581 1 case (isolated) 2 ld cathode 3 pd anode 4 ld anode / pd cathode mechanical dimensions (mm)
?2007 finisar corporation. all rights reserved. finisar is a regi stered trademark of finisar corporation. features and specific ations are subject to change without notice. rev. b 5/07 p h one : 1-866-my-vcsel usa (toll free) 1-214-509-2700 usa (direct dial) 44 (0) 174 336 5533 europe 886-935-409898 china & taiwan 81-90-4437-1130 japan 82-11-220-6153 asia pacific & korea f a x: 1-214-509-3709 usa email: support@adopco.com web: www.finisar.com/aoc.php advanced optical components finisar?s advanced optical components division was formed through strategic acquisition of key optical compon- ent suppliers. the company has led the industry in high volume vertical cavity surface emitting laser (vcsel) and associated detector technology since 1996. vcsels have become the primary laser source for optical data communi- cation, and are rapidly expanding into a wide variety of sensor applications. vcsels? superior reliability, low drive current, high coupled power, narrow and circularly symmetric beam and versatile packaging options (including arrays) are enabling solutions not possible with other optical technologies. advanced optical components is also a key supplier of fabrey-perot (fp) and distributed feedback (dfb) lasers, and optical isolators (oi) for use in single mode fiber data and telecommunications networks location allen, tx - business unit headquarters, vcsel wafer growth, wafer fabrication and to package assembly. fremont, ca ? wafer growth and fabrication of 1310 to 1550nm fp and dfb lasers. shanghai, prc ? optical passives assembly, including optical isolators and splitters. sales and service finisar?s advanced optical components division serves its customers through a worldwide network of sales offices and distributors. for application assistance, current specifications, pricing or name of the nearest authorized distributor, contact a nearby sales office or call the number listed below. aoc capabilities advanced optical components? advanced capabilities include: 1, 2, 4, 8, and 10gbps serial vcsel solutions 1, 2, 4, 8, and 10gbps serial sw detector solutions vcsel and detector arrays 1, 2, 4, 8, and 10gbps fp and dfb solutions at 1310 and 1550nm 1, 2, 4, 8, and 10gbps serial lw detector solutions optical isolators from 1260 to 1600nm range laser packaging in to46, to56, and optical subassemblies with sc, lc, and mu interfaces for communication networks vcsels operating at 670nm, 780nm, 980nm, and 1310nm in development sensor packages include surface mount, various plastics, chip on board, chipscale packages, etc. custom packaging options FP-1310-4I-LC 1310 nm fabry-perot (fp) laser diode
|
