2.0-6.0 ghz voltage regulator module 2.0-6.0 ghz voltage regulator module MWT-0206L-VRM/0206u-vrm MWT-0206L-VRM/0206u-vrm email: info@mwtinc.com www.mwtinc.com 4268 solar way fremont california 94538 phone: (510) 651-6700 fax: (510) 651-2208 4268 solar way fremont california 94538 phone: (510) 651-6700 fax: (510) 651-2208 dual adjustable voltage regulator typical specifications at 25 c integral 50 ohm line for rf interconnection current capability: up to 400ma per chip 800ma max per module built-in reverse voltage protection built-in thermal shutdown lm117 v out v in r1 r2 vo= 1.25 (1+r2/r1) voltage regulator circuit schematic electrical specifications (ta=25 c) symbol parameters units min typ ma x freq frequency range ghz 0.5 6.0 vin power supply voltage +v 10.7 12.0 20.0 v out1 regulated output voltage 1 (1) +v 7.9 8. 0 8.1 v out2 regulated output voltage 2 (2) +v 7.9 8. 0 8.1 idc dc current, total for two regulators ma 800 ir residual current ma 20.0 rr ripple rejection @ 120 hz db 50.0 pd max. dc power dissipation @ each regulator watts 1.5 (1) the output voltage can be adjusted between 1.25 volts to vin - 2.7 volts all rights reserved. microwave technology, inc. all specifications subject to change without notice.
2.0-6.0 ghz voltage regulator module 2.0-6.0 ghz voltage regulator module MWT-0206L-VRM/0206u-vrm MWT-0206L-VRM/0206u-vrm notes: construction email: info@mwtinc.com www.mwtinc.com 4268 solar way fremont california 94538 phone: (510) 651-6700 fax: (510) 651-2208 4268 solar way fremont california 94538 phone: (510) 651-6700 fax: (510) 651-2208 construction: notes: .055 max. w/caps & bond wires .055 max. w/caps & bond wires .041 .041 .025 .025 .490 .490 .600 .600 .110 .110 .095 .095 dc .08 .08 .505 .505 .08 .08 rf in rf in rf out rf out u l o o o o .087 .087 .113 .113 .183 .183 .209 .209 .296 .296 the 15 mil alumina substrate is brazed onto the 25 mil carrier using auge pre- form. the voltage regulators are attached utectically to the substrates. all other components are attached using ausn preforms. the flanges are designed to ac- commodate 0-80 unf-2a socket or fillister head screws on .500 center-to-center hole spacing. the modules are mechanically and electrically designed to be cas- caded. configurations 1. dimension in inches 2. tolerance: xxx= +/- .005 xx= +/- .01 1. custom module specifications and/or custom module mechanical configurations are available. 2. operating temperature range is -55 degrees celsius to +105 degrees celsius. 3. all modules are serialized and shipped with data measured at 25 degrees celsius. data includes swept small signal gain, swept input and output return loss. noise figure and p-1db are measured in 1 ghz increments. special module testing is available. 4. test fixtures are available. 5. microwave technology reserves the right to ship modules with performance above the typical specifications. dc all rights reserved. microwave technology, inc. all specifications subject to change without notice.
|
