led highly-diffused lights (75 mm) ? these models are not stocked and are non-returnable. printed in usa 05/01 p/n 67442 led highly-diffused light models 25.8 mm (1.02") 138.4 mm (5.45") 75 mm (2.95") light aperture 77.0 mm (3.03) m6 x 1.0 6.4 (0.25") deep (4x) 12.7 mm (0.50") 12.7 mm (0.50") 25.4 mm (1.00") 25.4 mm (1.00") 25.4 mm (1.00") see table 82.6 mm (3.25") 75 mm (2.95") light aperture models illumination t ype color cable supply v oltage supply current connections ledrs75n ? continuous highly-diffused light red 640 nm 0.5 m (18") terminated with 9-pin d-sub connector (male pins) 12v dc ?0% with voltage regulation of ?% 980 ma max. pin 1 = +v fan pin 2 = dc common fan pin 3 = dc common pin 4 = +v power supply model psa-12(e) or ps2v-12(e) is recommended (see other side) w arranty: banner engineering corp. warrants its products to be free from defects for one year. banner engineering corp. will repair or re place, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty peri od. this warranty does not cover damage or liability for the improper application of banner products. this warranty is in lieu of any other warranty either expr essed or implied. features ? designed to minimize surface textures and elevation changes, while providing uniform illumination over the field of view 59 mm x 75 mm light aperture the suggested field of view is 38 mm in diameter and the suggested stand off is 25 mm black anodized aluminum housing environmental rating iec ip20; nema 1 operating conditions t emperature: 0 to 40? (+32 to 104?) maximum relative humidity: 95% at 40? (non-condensing) useful life green model: 50,000 hours; red models: 60,000 hours. note: actual useful life of strobed lights depends on duty cycle green 530 nm LEDRS75N-S ? strobed highly-diffused light red 640 nm 24v dc ?0% with voltage regulation of ?% 7.0 a max. 1 ms pulse pin 4 or 5 = +v pin 1 or 6 = dc common use strobe control module model scm (see other side) ledgs75n ? 1.0 a max. 1.8 m (6') terminated with 9-pin d-sub connector (male pins)
banner engineering corp., 9714 tenth ave. no., mpls., mn 55441 ?ph: 763.544.3164 ?www.bannerengineering.com ?email: sensors@b annerengineering.com led highly-diffused lights (75 mm) accessories continuous power supplies models input input cord output output cable used with psa-12 100-250v ac 50/60 hz north america (nema 5-15) 12v dc ?% with voltage regulation of ?% 3.5 a max. 1.8 m (6') t erminated with 9-pin d-sub connector (female pins) continuous types: ledrs75n ledgs75n psa-12e cont. europe (schuko cee 7) psc-24e ? psc-24 ? 100-250v ac 50/60 hz north america (nema 5-15) 24v dc ?% with voltage regulation of ?% 2.2 a max. 1.8 m (6') 2-wire unterminated scm strobe control module (see below) cont. europe (schuko cee 7) models input input cord output output cable used with ps2v-12 ? 100-140v ac 60 hz north america (nema 5-15) 2-channels 6 - 12v dc 2 a max. per channel 1.8 m (6') t erminated with 9-pin d-sub connector (female pins) continuous types: ledrs75n ledgs75n v ariable power supplies (see data sheet p/n 67449) ps2v-12e ? cont. europe (schuko cee 7) models input t rigger input output output pulse range used with scm ? 24v dc 5% 2 a max. 5 - 12v dc pulse rising or falling (switch selectable) 10 ma max. 2-channels 24v dc ?% 9 a nominal per channel @ 60 hz 5 to 1,300 microseconds strobed types: LEDRS75N-S strobe control module (see data sheet p/n 67448) extension cables models length configuration used with db906 ? 1.8 m (6') t erminated both ends with 9-pin d-sub connector, for continuous lights (one end male pins and opposite end female pins) continuous types: ledrs75n ledgs75n db910 ? 3.0 m (10') db9y ? 1.8 m (6') y cable for powering 2 lights from one supply, for continuous lights db910s ? 3.0 m (10') db906s ? 1.8 m (6') t erminated both ends with 9-pin d-sub connector, for strobed lights (one end male pins and opposite end female pins) db9ys ? strobed types: LEDRS75N-S 1.8 m (6') y cable for powering 2 lights from one supply, for strobed lights (use power supply psc-24 or psc-24e) ? these models are not stocked and are non-returnable. 200-250v ac 50 hz
|
