www.boser.com.tw industrial power supply redundant ARI-6400F 400w redundant power supply *input voltage: 90~132vac or 180~260vac selectable *input frequency: 47~63hz *input current: 10a at 115vac or 6a at 230vac max. *inrush current: < 50a at 100vac, < 100a at 220vac, < 60a at 230vac input cold start, 25 o c excluding emi capacitors *load range: at 100% max. load condition in all outputs, +5v output is between 4.98v and 5.02v, +3.3v is between +3.25v and +3.35v. all other outputs are within their specified voltage accuracy ranges *ripple and noise: peak to peak ripple and noise for +5v and +3.3v outputs are < 60mv, and < 120mv for -5v, +12v, and +5vsb outputs *line regulation: < +/-1% for +5v, +12v, -12v, and +5vsb outputs. +3.3v is +/-2% *hold up time: > 16ms at 115vac or 230vac input and max. load measured from the last ac line charging pulse to the point when +5v drops down to +4.75v *output power: total dc continuous power is within 400w at < 30 o c ambient temperature *power good signal: signal goes high from 100~500ms after all output dc voltages are within regulation limits *power redundancy: this power supply has power redundant capability *efficiency: 65% typical, measured at nominal line and rated load *protection: built-in over voltage protection circuit. trip point between 5.7~7.0v ac line off and on cycle for over voltage protection recovery latch off mode against short circuit or over load conditions *dimensions: 19.2 x 16.8 x 22.0 cm features features *safety: ul 1950 / csa 1402c & csa 950 / tuv en60950 *earth continuity resistance: fg to hg > 0.01 ohm11 *emi: fcc part 15 class b rules vde safety standards safety standards dc output wires 8.5 0.45 13.4 2.1 16.8 16.0 9.0 3.5 19.2 22.0 6.9 output voltage +5v +12v -12v -5v min. load 7a 2.5a 0a 0a rated load 25a 16a 0.8a 0.8a max. load 36a 17a 0.8a 0.8a voltage accuracy 4.75~5.25v 11.4~12.9v -11.30~-12.6v -4.65~-5.25v +3.3v +5vsb 3a 0.1a 20a 0.75a 25a 2a 3.15~3.45v 4.8~5.2v
|
