2107 n. first street, suite 415 phone (408) 452-1277 san jose, ca 95131 toll free (800) 445-5511 http://www.memtech.com ver 1.2 fax (408) 452-7936 at3515 bulldog 3.5? ide solid state drive ? 128 mbyte to 8 gbyte uncompressed capacity ? full -40 o c to +85 o c industrial temperature range ? low profile 3.5? drive form-factor ? standard 40-pin, unitized ide interface ? 72-bit ecc for exceptional data reliability ? 5 volt, low power operation ? completely solid state - no moving parts ? 1000g operating shock ? 15g operating vibration ? 6 mbytes/sec read throughput ? 6 mbytes/sec write throughput ? 10 year data integrity the at3515 is an entry-level low cost solid-state flash drive, with a maximum capacity of 8 gbyte in an extremely compact low profile 3.5? form-factor. it is completely solid state, with no moving parts. this contribut es to the unit?s exceptional ruggedness and wide operating temperature r ange; with no moving parts, there is no mechanism for mechanical wear-out. being 100% ide compatible, no special drivers or flash file managers are required. it is a virtual drop in replacement for standard rotating media. the at3515 employs sector erasable nand e 2 proms (flash) to deliver up to 8 gbytes of uncompressed, non-volatile solid state storage in an extremely small, rugged form factor. sequential sustained data throughput is up to 6 mbytes/sec for reads and 6 mbytes/sec for writes. the drive suppor ts up to pio mode-4 and dma mode-2 bus access, multi-sector transfers, as well as lba addressing. it is 100% ide compatible and requires no special drivers to operate the drive is implemented using a custom ide flash controller with multi-tasking technology. an integrated 72-bit reed-solomon error detection and correction mechanism and proprietary remapping and wear-leveling technology along with a power hold-up circuit greatly improve data reliability. its? cost effectiveness and low-power operation make the at3515 ideal for applications requiring high reliability at a low cost up to 8 gbytes of data storage. the drive is available in a number of standar d capacities from 128 to 8 gbyte. please contact the factory for specific size availability.
at3515 data sheet version 1.2 4/10/2006 each drive is fully tested under environmental and voltage extremes to guarantee data integrity under even the harshest conditions. the drive may be mounted in any orientation. bottom and side mounting holes are available that conform to the 3.5? ide drive standard. specifications* interface ide compatibility x3t10 2008d, rev. 6 ide mode support up to pio mode 4 ide drive number drive 0 or 1 physical capacity 8 gbyte physical sector size 512 bytes performance sequential read 6 mbytes/sec sequential write 6 mbytes/sec burst read 16.6 mbytes/sec burst write 16.6 mbytes/sec environmental operating temperature range commercial 0 o to +70 o c extended -20 o to +75 o c industrial -40 o to +85 o c storage temperature -55 o to +125 o c shock - operating 1000g, half sine vibration - operating 15g random airflow none required humidity 5% to 95% nc safety csa file lr114427 emc en55022 and en50082-1 reliability endurance application specific 8kbytes/30 sec 3.2 million hours ecc 72-bit reed solomon power requirements voltage 5v +/- 5% current at3515-1024 sleep 45 ma read 90 ma write 112 ma mechanical length 5.56 inches (141.2 mm) width 4.0 inches (101.6 mm) height 0.50 inches (12.7 mm) cable interface unitized 40-pin ide and 4-pin power max. cable length 18 inches (457 mm) rec. cable length 12 inches (305 mm) weight (4 gbytes) 6.4 oz 181 g) * specifications subjec t to change without notice.
|
