 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| PHASE ANGLE ELECTRONIC HEAT SWITCH UP TO 15A QLC X10206 INTRODUCTION These switchable phase angle power regulators are robust and compact units, ideal for controlling single phase mains driven loads. The standard QLC units are for 230V supply, with an integral three position and off control switch. The large triac enables the unit to handle high inrush currents with ample safety margin on industrial installations. An adhesive backed silver label and hairline knob are available as optional extras. APPLICATIONS Suitable for quartz lamps, conventional resistive heating elements in series or parallel configurations. Applications including ovens, moulders, dryers and some inductive loads, such as, transformers and motors. FEATURES * Large triac for inrush protection. * Three position & off control. * Single hole fixing. * Rugged and compact. * Optional knob & dial. INSTALLATION INSTALLATION SPECIFICATIONS Triac limiting RMS. On state current 26A Unit limiting RMS. On state current 15A Peak single cycle surge @ 10mS 320A Max load at 20C ambient (without extra heatsink)10A Max unit operating temperature 65C FURTHER DIMENSIONS Shaft diameter Bush length Isolation voltage I2t limiting value for fusing Mains supply ( within 10%) Min operating current Unit storage temperature range 2500V rms 112A2s 230V ac @ 50/60 Hz 200mA -20 to +85C 6.3mm 5mm Shaft projection from bush Standard cable length 30mm 400mm FUSING: It is recommended to use semiconductor (fast acting) type fuses or circuit breakers (Semiconductor - MCB) for unit protection. On initial `switch on' some loads may need an increased Factor of Safety (F of S) for unit and/or device protection. (See SRA Datasheet for further information). CE MARKING This product family carries a "CE" mark. This phase angle controller needs a suitable remote filter. For information see recommendation section and contact our sales desk. (See Declaration of Conformity). RECOMMENDATION Other documents available on request, which may be appropriate for your applications. CODE IDENTITY DESCRIPTION X10229 RFI Filtering recommendation - addressing EMC Directive X10213 ITA Interaction, uses for phase angle and for burst fire control. X10255 SRA Safety requirements - addressing the Low Voltage Directive (LVD) including :- Thermal data/cooling ; "Live" parts warning & Earthing requirements; Fusing recommendations. AP02/4 COS UAL Conditions of sale NOTE It is recommended that installation and maintenance of this equipment should be done with reference to the current edition of the I.E.E wiring regulations (BS7671) by suitably qualified/trained personnel. The regulations contain important requirements regarding safety of electrical equipment. (For International standards refer to I.E.C directive IEC 950). ORDER CODE State part number: QLC 230V AC Optional extras include: Knob, Dial, Heatsink paste, Filter. Note: When ordering a filter the maximum current the QLC is to be used at will be required. UNITED AUTOMATION LIMITED 1 Southport Business Park Southport, PR8 4HQ, U.K. Page No 2 of 2 Issue 2 17/07/98 Tel (01704)-565713 Fax (01704)-569760 |
Price & Availability of QLC-R
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |