View TPDC200P-48B-490O_1328066.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

36-72VDC INPUT RANGE DC-DC CONVERTER HOT-SWAP CompactPCI QUAD OUTPUT 200 WATTS CURRENT SHARING SWITCHING POWER SUPPLIES TPDC200P-48B SERIES
FEATURES:
200W IN 3U X 8HP EUROCARD PACKAGE CompactPCI DC-DC CONVERTER INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY DROOP CURRENT SHARING HOT-SWAPPABLE EMI MEET EN55022/FCC CLASS B CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG
TOTAL POWER INT'L
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: Typ. 36-72Vdc nominal 48Vdc. Input Connector: Positronic 47-pin PCIH47M400A1. Inrush Current: Cold start 8A @ 72 Vdc. (Active) Input Current: 4.5A @ nominal 48Vdc. Dielectric Withstand: Meet IEC950 regulation. EMI: Meet CISPR EN55022 & FCC Class B. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection: Installed NTC for thermal sensor at [DEG#] pin. Overload Protection (OLP): Fully protected against output oveload or short circuit. Typ. set at 150% max. load. Consult the factory for special OLP setting.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 200W continuous. Output Connector: Positronic 47-pin PCIH47M400A1. Line Regulation: Typ. 0.5% over DC input range. Load Regulation: Typ. 1.0-2.0%. Noise & Ripple: Typ. 1% peak to peak or 50mV, which is greater. OVP: Built-in at VO1 & VO2. Adjustability: Available at VO1 & VO2. VO3 factory set. Remote Sensing: Available at VO1,VO2 & VO3. Hot-Swap: Available. N+1 Redundancy: Installed with internal OR-ing diodes at all outputs for N+1 redundancy operation. Current Sharing: Droop current sharing method for all outputs. Operating Temperature: 0 to +50C at full load with specified air flow. Derates linearly to 50% at +70C. Storage Temperature: -40 to +85C. Temperature Coefficient: Typ. 0.02% /C. Cooling: At least 20 cfm (600 lfm) moving air is required to achieve full rating power. Power Density: 3.7 Watts / Cubic Inch.
GENERAL SPECIFICATION
Efficiency: Typ. 79%. Switching Frequency: 130 KHz. Circuit Topology: Forward circuit. Transient Response: Peak transient less than 200mV and recovers within 3mS after 25% load-change. Safety Standard: IEC950/ UL1950. Construction: Eurocard 3U x 8HP x 160mm CompactPCI format. Front Panel with either Ordinary handle or Extractor handle.
Note: All measurements are at nominal input, full load, and +25C unless otherwise specifications.
TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -1-
OUTPUT VOLTAGE / CURRENT RATINGS CHART
QUAD OUTPUT
MAIN +VO1 @ #= MODEL NO. Min. Typ. Volt. Max. +5V +5V 35A 35A AUX. +VO2 @ #= Typ. 10A 10A Volt. +3.3V +3.3V Max. 20A 20A AUX. +VO3 =#(@) Typ. Volt. Max. Peak AUX. -VO4 = Typ. Volt Max. Peak
TPDC200P-48B-490(E) 2.0A 25A TPDC200P-48B-490(O) 2.0A 25A
3.0A +12V 5.0A 6.0A 0.5A -12V 1.0A 1.0A 3.0A +12V 5.0A 6.0A 0.5A -12V 1.0A 1.0A
Symbol: "" OVP built-in. "@" Adjustable. "(@)" Adjustable factory set. "#" Remote sensing. "=" Droop Current Sharing. "" Installed with Or-ing diode. "" Magnetic Amplifier. "" Installed with Post Regulator. "" Common Choke. Remark: Peak load less than 60sec. with duty cycle <10%. Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time.
MECHANICAL DIMENSIONS: MM [INCHES]
WEIGHT: 666.0g (23.5 Oz.)
TPDC200P-48B-490(E)
TPDC200P-48B-490(O)
INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT
DC INPUT ASSIGNMENT -Vin +Vin G CNTR &PIN # 47 46 45 QUAD OUTPUT VO1 1,2, 3,4 S+ 30 S34 VO2 13,14,15,16,17,18 S+ 33 VO3 20 S+ 36 VO4 21 DC COM 5,6,7,8,9,10,11,12, 19,22,24 EN# 27 STATUS/CONTROL DEG# 38 INH# FAL# 39 42
Mating connector: PCIH47F400A1.
TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -2-

▲Up To Search▲

Price & Availability of TPDC200P-48B-490O

	To Download TPDC200P-48B-490O Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .