 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| FUJITSU MEDIA DEVICE DATA SHEET DS04-21710-2E ASSP Piezoelectric VCO (6 MHz to 30 MHz) M2 Series (F150) s DESCRIPTION The M2 series (F150) of VCO (Voltage Controlled Oscillator) apply to the frequency range 6 MHz to 30 MHz. These VCOs have a high stability and wide controllable frequency ranges using a LiTaO3 piezoelectric single crystal with high electromechanical coupling coefficient. Output level applies to CMOS type for digital interface. s FEATURES * * * * * * Wide frequency controllable range (Over than 2000 ppm) High carrier noise ratio Excellent temperature stability CMOS output level Compact package (8 mm x 11 mm x 2.6 mm) Surface mountable package (SMD) s PACKAGE M2 Series (F150) s PIN ASSIGNMENT (Bottom View) 3 4 2 1 s PIN DESCRIPTIONS Pin No. 1 2 3 4 Symbol VIN GND VCC VOUT GROUND VCC (Supply voltage) OUTPUT Descriptions INPUT (Control voltage) 2 M2 Series (F150) s ABSOLUTE MAXIMUM RATINGS Parameter Supply voltage Control voltage Output voltage Output current Operating temperature Storage temperature Symbol VCC VIN VOUT IOUT Ta Tstg Rating Min. -0.5 -0.5 -0.5 -25 -10 -40 Max. +7.0 +7.0 VCC +0.5 +25 +70 +100 Unit V V V mA C C WARNING: Piezoelectric devices can be permanently damaged by application of stress (voltage, current, temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings. s RECOMMENDED OPERATING CONDITIONS Parameter Supply voltage Control voltage Operating temperature Symbol VCC VIN Ta Value Min. +4.75 0 -10 Max. +5.25 +5.0 +70 Unit V V C WARNING: The recommended operating conditions are required in order to ensure the normal operation of the piezoelectric device. All of the device's electrical characteristics are warranted when the device is operated within these ranges. Always use semiconductor devices within their recommended operating condition ranges. Operation outside these ranges may adversely affect reliability and could result in device failure. No warranty is made with respect to uses, operating conditions, or combinations not represented on the data sheet. Users considering application outside the listed conditions are advised to contact their FUJITSU representatives beforehand. s STANDARD FREQUENCIES Nominal frequency 13.500 MHz 14.318 MHz 16.934 MHz 18.432 MHz 24.576 MHz 25.175 MHz 27.000 MHz 33.869 MHz Part number FAR-M2CC-13M500-F150 FAR-M2CC-14M318-F150 FAR-M2CC-16M934-F150 FAR-M2CC-18M432-F150 FAR-M2CC-24M576-F150 FAR-M2CC-25M175-F150 FAR-M2CC-27M000-F150 FAR-M2CC-33M869-F150 Application Video Video Audio Video Audio Display Video Audio 3 M2 Series (F150) s ELECTRICAL CHARACTERISTICS Parameter Current consumption Output voltage "H" "L" Symbol ICC VOH VOL fH fL f(VCC) f(Ta) Condition Without load VIN = 2.5 V VIN = 5.0 V VIN = 0.0 V VCC = 4.75 V to 5.25 V VIN = 2.5 V VIN = 2.5 V Ta = -10 C to +70 C Value Min. -- VCC - 0.5 -- +2000 -- -150 -500 Typ. 5.0 5.0 0 -- -- -- -- Max. 10 -- +0.5 -- -2000 +150 +500 Unit mA V V ppm Nominal frequency ppm reference VCC = 5.0 ppm reference V ppm 25C reference Remarks Oscillation frequency Frequency stability Frequency stability with temperature Unless otherwise specified Ta = +25 C, VCC = 5.0 V s MEASURMENT CIRCUIT VCC 0.1 F 3 VIN 1 Output 4 CL = 22 pF 2 GND CL includes capacitance of probe and test fixture 4 M2 Series (F150) s TYPICAL CHARACTERISTICS Part number: FAR-M2CC-16M934-F150 1. Control Voltage vs. Oscillation Frequency Variation 6000 Oscillation frequency variation (ppm) 4000 2000 0 -2000 -4000 -6000 0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 Control voltage (V) 2. Temperature Characteristics 1000 Oscillation frequency variation (ppm) 800 600 400 200 0 -200 -400 -600 -800 -1000 -20 -10 0 10 20 30 40 50 60 70 80 Temperature (degree C) 3. Supply Voltage (Vcc) vs. Oscillation Frequency Variation 500 Oscillation frequency variation (ppm) 400 300 200 100 0 -100 -200 -300 -400 -500 4.5 4.75 5 Supply voltage (V) 5.25 5.5 5 M2 Series (F150) s PART NUMBER DESIGNATION [Designation example] FAR - M2CC - (1) - F150 - R (2) (1) : Frequency : This specifies the nominal frequency using six alphanumeric characters. M indicates the decimal point. [Example] 24.576 MHz 24M576 (2) : Taping : "-R" means 1000 pcs/reel s MARKING Logo Frequency F 24M576 Lot Number Index 6 M2 Series (F150) s PACKAGE DIMENSION 9.90 +0.00 -0.20 7.60 0.10 0.60 0.10 2.60 0.15 0.80 2.00 0.80 1.60 8.00 0.20 5.10 11.00 0.50 Dimensions in mm. s RECOMMENDED LAND PATTERN 5.08 2.0 2.4 11.0 Dimensions in mm. 6.36 8.0 7 M2 Series (F150) s PACKAGE: Reel type 1. Reel Dimensions 25.5 1.5 13.0 0.5 21 0.8 330 2.0 80 1.5 0.2 Type Quantity R 1 k pcs 2. Packing style Peel side Pulling side Pulling side 8 M2 Series (F150) 3. Tape Dimensions 4.0 0.1 2.0 0.1 1.5 -0.0 +0.1 1.75 0.1 0 . 3 0.0 5 11.5 0.1 12.1 0.1 24.0 0.3 8.8 0.1 12.0 0.1 2.0 +0.1 -0.0 4. Peel strength of top cover tape Peel off by the force of 0.1 N to 1.0 N under the condition at the right. (Conforms to JIS C 0806 section 3) 165 to 180 Direction of pulling Speed 300 mm/min Embossment carrier type tape 11.8 0.1 3 .2 0 .1 9 M2 Series (F150) s RECOMMENDED REFLOW PROFILE 235 10 s Temperature (C) Heating ratio 1 C/s to 4 C/s 210 Air cooling 40 s Pre-Heating 150 60 s 90 s Time (s) s NOTE A mass-produced product order is accepted by a unit of 1000. 10 M2 Series (F150) FUJITSU MEDIA DEVICES LIMITED All Rights Reserved. The contents of this document are subject to change without notice. Customers are advised to consult with FUJITSU MEDIA DEVICES sales representatives before ordering. The information and circuit diagrams in this document are presented as examples of device applications, and are not intended to be incorporated in devices for actual use. Also, FUJITSU MEDIA DEVICES is unable to assume responsibility for infringement of any patent rights or other rights of third parties arising from the use of this information or circuit diagrams. The products described in this document are designed, and manufactured as contemplated for general use, including without limitation, ordinary industrial use, general office use, personal use, and household use, but are not designed, developed and manufactured as contemplated (1) for use accompanying fatal risks or dangers that, unless extremely high safety is secured, could have a serious effect to the public, and could lead directly to death, personal injury, severe physical damage or other loss (i.e., nuclear reaction control in nuclear facility, aircraft flight control, air traffic control, mass transport control, medical life support system, missile launch control in weapon system), or (2) for use requiring extremely high reliability (i.e., submersible repeater and artificial satellite). Please note that Fujitsu will not be liable against you and/or any third party for any claims or damages arising in connection with above-mentioned uses of the products. Any electronic devices have inherently a certain rate of failure. You must protect against injury, damage or loss from such failures by incorporating safety design measures into your facility and equipment such as redundancy, fire protection, and prevention of over-current levels and other abnormal operating conditions. If any products described in this document represent goods or technologies subject to certain restrictions on export under the Foreign Exchange and Foreign Trade Control Law of Japan, the prior authorization by Japanese government should be required for export of those products from Japan. F0104 (c) FUJITSU LIMITED Printed in Japan |
Price & Availability of E421710
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |