![]() |
|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
PM600HSA120 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 IntellimodTM Module Half Phase IGBT Inverter Output 600 Amperes/1200 Volts A B E E F S E W 1. 2. 3. 4. 5. V1 SR C1 VC FO H C H K 123 45 L N M C Y - (4 TYP.) D AA - DIA. Z - DIA. Q S X - DIA. V - DIA. (4 TYP.) P T - M8 THD 0.64 MM SQ. PIN (5 TYP.) R FIGURE A SEE FIGURE A G J U Description: Powerex IntellimodTM Intelligent Power Modules are isolated base modules designed for power switching applications operating at frequencies to 20kHz. Built-in control circuits provide optimum gate drive and protection for the IGBT and free-wheel diode power devices. Features: Complete Output Power Circuit Gate Drive Circuit Protection Logic - Short Circuit - Over Current - Over Temperature - Under Voltage V1 C VCC FO SR C1 VC FO TEMP OUT1 SR IN GND OUT2 SENS SINK E Outline Drawing and Circuit Diagram Dimensions A B C D E F G H J K L M N Inches 5.24 4.330.01 3.98 3.230.01 2.16 1.97 Millimeters 133.0 110.00.25 101.0 82.00.25 55.0 50.0 Dimensions P Q R S T U V W X Y Z AA Inches 0.71 0.41 0.37 0.35 M8 Metric 0.28 0.26 Dia. 0.02 0.02 Dia. 0.100 0.09 Dia. 0.04 Dia. Millimeters 18.0 10.5 9.5 9.0 M8 7.0 Dia. 6.5 5.0 Dia. 5.0 2.54 Dia. 2.3 Dia. 1.0 Applications: Inverters UPS Motion/Servo Control Power Supplies Ordering Information: Example: Select the complete part number from the table below -i.e. PM600HSA120 is a 1200V, 600 Ampere IntellimodTM Intelligent Power Module. Type PM Current Rating Amperes 600 VCES Volts (x 10) 120 1.42 +0.04/-0.02 36.0 +1.0/-0.5 1.42 1.33 1.25 1.02 0.80 0.79 36.0 33.7 31.7 26.0 20.3 20.0 683 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM600HSA120 IntellimodTM Module Half Phase IGBT Inverter Output 600 Amperes/1200 Volts Absolute Maximum Ratings, Tj = 25C unless otherwise specified Characteristics Power Device Junction Temperature Storage Temperature Case Operating Temperature Mounting Torque, M6 Mounting Screws Mounting Torque, M8 Main Terminal Screws Module Weight (Typical) Supply Voltage Protected by OC and SC (VD = 13.5 - 16.5V, Inverter Part) Isolation Voltage, AC 1 minute, 60Hz Sinusoidal Symbol Tj Tstg TC -- -- -- VCC(prot.) VRMS PM600HSA120 -20 to 150 -40 to 125 -20 to 100 26 95 1090 800 2500 Units C C C in-lb in-lb Grams Volts Volts Control Sector Supply Voltage Applied between (V1-VC) Input Voltage Applied between (C1-VC) Fault Output Supply Voltage (Applied between Fo-Vc) Fault Output Current VD VCIN VFO IFO 20 10 20 20 Volts Volts Volts mA IGBT Inverter Sector Collector-Emitter Voltage (VD = 15V, VCIN = 5V) Collector Current, Peak Collector Current, Collector Dissipation VCES IC ICP PC 1200 600 1200 3470 Volts Amperes Amperes Watts Electrical and Mechanical Characteristics, Tj = 25C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units Control Sector Over Current Trip Level Inverter Part Short Circuit Trip Level Inverter Part Over Current Delay Time Over Temperature Protection OC SC toff(OC) OT OTR Supply Circuit Under Voltage Protection UV UVR Supply Voltage Circuit Current Input ON Threshold Voltage Input OFF Threshold Voltage PWM Input Frequency Fault Output Current VD ID VCIN(on) VCIN(off) fPWM IFO(H) IFO(L) Minimum Fault Output Pulse Width SXR Terminal Output Voltage tFO VSXR -20C Tj 125C -20C Tj 125C VD = 15V Trip Level Reset Level Trip Level Reset Level Applied between V1-VC VD = 15V, VCIN = 5V, V1-VC Applied between C1-VC Applied between C1-VC 3Sinusoidal VD = 15V, VFO = 15V VD = 15V, VFO = 15V VD = 15V Tj 125C, Rin = 6.8 k 740 1000 -- 100 85 11.5 -- 13.5 -- 1.2 1.7 -- -- -- 1.0 4.5 1000 1400 5 110 95 12.0 12.5 15 23 1.5 2.0 15 -- 10 1.8 5.1 -- -- -- 120 105 12.5 -- 16.5 30 1.8 2.3 20 0.01 15 -- 5.6 Amperes Amperes S C C Volts Volts Volts mA Volts Volts kHz mA mA mS Volts 684 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM600HSA120 IntellimodTM Module Half Phase IGBT Inverter Output 600 Amperes/1200 Volts Electrical and Mechanical Characteristics, Tj = 25C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units IGBT Inverter Sector Collector Cutoff Current ICEX VFM VCE(sat) VCE = VCES, Tj = 25C VCE = VCES, Tj = 125C Diode Forward Voltage Collector-Emitter Saturation Voltage -IC = 600A, VD = 15V, VCIN = 5V VD = 15V, VCIN = 0V, IC = 600A, Tj = 25C, Pulsed VD = 15V, VCIN = 0V, IC = 600A, Tj = 125C, Pulsed Inductive Load Switching Times ton trr tC(on) toff tC(off) VD = 15V, VCIN = 0 ~ 5V VCC = 600V, IC = 600A Tj = 125C 0.5 -- -- -- -- 1.4 0.2 0.4 3.0 0.6 2.5 0.4 1.0 4.0 1.1 S S S S S -- 2.1 2.9 Volts -- -- -- -- -- -- 2.5 2.3 1.0 10 3.5 3.2 mA mA Volts Volts Thermal Characteristics Characteristic Junction to Case Thermal Resistance Symbol Rth(j-c)Q Rth(j-c)D Contact Thermal Resistance Rth(c-f) Condition Each IGBT Each FWDi Case to Fin Per Module, Thermal Grease Applied Min. -- -- -- Typ. -- -- -- Max. 0.036 0.06 0.025 Units C/Watt C/Watt C/Watt Recommended Conditions for Use Characteristic Supply Voltage Symbol VCC VD Input ON Voltage Input OFF Voltage PWM Input Frequency Minimum Dead Time VCIN(on) VCIN(off) fPWM tDEAD Condition Applied across C1-E2 Terminals Applied between V1-VC Applied between C1-VC Applied between C1-VC Using Application Circuit Input Signal Value 0 ~ 800 15 1.5 0 ~ 0.8 Units Volts Volts Volts 4.0 ~ VSXR Volts 5 ~ 20 4.0 kHz S 685 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM600HSA120 IntellimodTM Module Half Phase IGBT Inverter Output 600 Amperes/1200 Volts SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) OUTPUT CHARACTERISTICS (TYPICAL) 5 SATURATION VOLTAGE VCE(sat), (VOLTS) 5 VD = 15V Tj = 25oC Tj = 125oC COLLECTOR-EMITTER SATURATION VOLTAGE VCE(sat), (VOLTS) COLLECTOR CURRENT, IC, (AMPERES) 4 4 IC = 600A Tj = 25oC Tj = 125oC 1000 Tj = 25oC VD = 17V 13 15 800 3 3 600 2 2 400 1 1 200 0 0 200 400 600 800 1000 COLLECTOR CURRENT, IC, (AMPERES) 0 10 12 14 16 18 20 SUPPLY VOLTAGE, VD, (VOLTS) 0 0 1 2 3 4 5 COLLECTOR-EMITTER VOLTAGE, VCE(sat), (VOLTS) SWITCHING TIME VS. COLLECTOR CURRENT (TYPICAL) REVERSE RECOVERY CURRENT VS. COLLECTOR CURRENT (TYPICAL) DIODE FORWARD CHARACTERISTICS 101 REVERSE RECOVERY TIME, trr, (S) 100 VCC = 600V VD = 15V Tj = 125oC VCC = 600V VD = 15V Tj = 125oC Irr trr 103 REVERSE RECOVERY CURRENT, Irr, (AMPERES) DIODE FORWARD CURRENT, IE, (AMPERES) 103 Tj = 25oC Tj = 125oC SWITCHING TIMES, ton, toff, (s) toff ton 100 tc(off) 10-1 102 102 tc(on) 10-1 101 102 COLLECTOR CURRENT, IC, (AMPERES) 103 10-2 101 102 COLLECTOR CURRENT, IC, (AMPERES) 101 103 101 0 1 2 3 DIODE FORWARD VOLTAGE, VCE, (VOLTS) TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (IGBT) TRANSIENT IMPEDANCE, Zth(j-c), (NORMALIZED VALUE) TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (FWDi) TRANSIENT IMPEDANCE, Zth(j-c), (NORMALIZED VALUE) 101 101 100 100 10-1 10-1 10-2 SINGLE PULSE STANDARD VALUE = Rth(j-c)Q = 0.036oC/W 10-2 SINGLE PULSE STANDARD VALUE = Rth(j-c)D = 0.06oC/W 10-3 10-3 10-2 10-1 TIME, (s) 100 101 10-3 10-3 10-2 10-1 TIME, (s) 100 101 686 |
Price & Availability of PM600HSA12
![]() |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |