View BC550C_201762.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

Continental Device India Limited
An IS/ISO 9002 and IECQ Certified Manufacturer
IS/ISO 9002 Lic# QSC/L- 000019.2
NPN SILICON PLANAR EPITAXIAL TRANSISTORS
BC549, A, B, C BC550, A, B, C TO-92 Plastic Package
General Purpose Transistors, Best Suited For Use in Driver Stages of Audio Amplifiers, of Tape Recorders. Low Noise Input stages , Hi-Fi Amplifiers, Signal Processing Circuits of Television Receivers.
ABSOLUTE MAXIMUM RATINGS(Ta=25C unless specified otherwise) DESCRIPTION SYMBOL Collector Emitter Voltage Collector Base Voltage Emitter Base Voltage Collector Current Continuous Power Dissipation @ Ta=25C Derate Above 25C Power Dissipation @ Tc=25C Derate Above 25C Operating And Storage Junction Temperature Range THERMAL RESISTANCE Junction to ambient Junction to case VCEO VCBO VEBO IC PD PD Tj, Tstg BC549 30 30 5 100 625 5 1.5 12 -55 to +150 BC550 45 50 5 UNITS V V V mA mW mW/C W mW/C C
Rth(j-a) Rth(j-c)
200 83.3
C/W C/W
Continental Device India Limited
Data Sheet
Page 1 of 5
NPN SILICON PLANAR EPITAXIAL TRANSISTORS
BC549, A, B, C BC550, A, B, C TO-92 Plastic Package
ELECTRICAL CHARACTERISTICS (Ta=25C Unless Specified Otherwise) DESCRIPTION SYMBOL TEST CONDITION Collector Emitter Voltage VCEO IC=10mA,IB=0 BC549 BC550 Collector Base Voltage IC=10A,IE=0 VCBO BC549 BC550 VEBO IE=10A, IC=0 Emitter Base Voltage Collector Cut off Current ICBO VCB=30V, IE = 0 VCB=30V, IE = 0, Ta= +125C EmitterCut off Current DC Current Gain B C BC549,BC550 A B C Collector Emitter Saturation Voltage VCE(sat) IC=10mA,IB=0.5mA IC=10mA,IB=see note1 IC=100mA,IB=5mA* Base Emitter Saturation Voltage Base Emitter On Voltage VBE(sat) VBE(on) IC=100mA,IB=5mA* IC=10A,VCE=5V IC=100A,VCE=5V IC=2mA,VCE=5V hFE VCE=5V,IC=10uA IEBO VEB=4V, IC = 0
MIN 30 45 30 50 5
TYP
MAX
UNITS V V V V V
15 5
nA A
15
nA
100 100 110 110 200 420
150 270 800 220 450 800
VCE=5V,IC=2mA
290 500
0.075 0.30 0.25 1.1 0.52 0.55 0.62
0.25 0.6 0.6
V V V V V V V
0.55
0.70
Continental Device India Limited
Data Sheet
Page 2 of 5
NPN SILICON PLANAR EPITAXIAL TRANSISTORS
BC549, A, B, C BC550, A, B, C TO-92 Plastic Package
ELECTRICAL CHARACTERISTICS (Ta=25C Unless Specified Otherwise) DESCRIPTION DYNAMICS CHARACTERISTICS Transition Frequency Collector Output Capacitance Noise Figure fT Ccbo NF1* IC=10mA, VCE=5V f=100MHz IE=0, VCE=10V f=1MHz VCE =5V,IC=200A RS=2K,f=30HZ -15Kz VCE =5V,IC=200uA RS=100K,f=1.0KHZ 250 2.50 0.6 2.5 MHz pF dB SYMBOL TEST CONDITION MIN TYP MAX UNITS
NF2
10
dB
Small Signal Current Gain BC549, BC550 B C
| hfe |
VCE =5V,IC=2mA f=1KHZ
125 240 450
330 600
900 500 900
NOTE 1 : IB is value for which IC = 11mA at VCE =1V *Pulse Condition: = Pulse Width < 300us, Duty Cycle < 2%.
Continental Device India Limited
Data Sheet
Page 3 of 5
BC549, A, B, C BC550, A, B, C TO-92 Plastic Package TO-92 Plastic Package
TO-92 Transistors on Tape and Ammo Pack
Dimension With 'L'
B
Uncontrolled
Ammo Pack Style
MECHANICAL DATA
T P h A A1 (p)
Adhesive Tape on Top Side
D FEE
Carrier Strip 183 mm
h
LABEL
FLAT SIDE
A
H1
H0 L
W2
Wo W1 W
L
Solderability Ensured
t1 t F1 F P2 Po F2 Do
331 mm
42 mm
Beyond 'L'
K
1 2 3 D G AA
Flat Side of Transistor and Adhesive Tape Visible 2000 pcs./Ammo Pack
All dimensions in mm unless specified otherwise
D 3 E 2 1
ITEM BODY WIDTH BODY HEIGHT BODY THICKNESS PITCH OF COMPONENT FEED HOLE PITCH FEED HOLE CENTRE TO COMPONENT CENTRE DISTANCE BETWEEN OUTER LEADS COMPONENT ALIGNMENT TAPE WIDTH HOLD-DOWN TAPE WIDTH HOLE POSITION HOLD-DOWN TAPE POSITION LEAD WIRE CLINCH HEIGHT COMPONENT HEIGHT LENGTH OF SNIPPED LEADS FEED HOLE DIAMETER TOTAL TAPE THICKNESS LEAD - TO - LEAD DISTANCEF1, CLINCH HEIGHT PULL - OUT FORCE
SYMBOL A1 A T P Po P2 F h W Wo W1 W2 Ho H1 L Do t F2 H2 (P)
SEC AA DIM MIN. 4.32 4.45 3.18 0.41 MAX. 5.33 5.20 4.19 0.55
F
F
321
A B C D E F G H K L
PIN CONFIGURATION 1. EMITTER 2. BASE 3. COLLECTOR
0.35 0.50 5 DEG 1.14 1.40 1.14 1.53 12.70 1.982 -- 2.082
SPECIFICATION REMARKS MIN. NOM. MAX. TOL . 4.0 4.8 5.2 4.8 4.2 3.9 12.7 1 12.7 0.3 CUMULATIVE PITCH ERROR 1.0 mm/20 PITCH 6.35 0.4 TO BE MEASURED AT BOTTOM OF CLINCH +0.6 5.08 -0.2 0 1 AT TOP OF BODY 18 0.5 6 0.2 9 +0.7 -0.5 0.5 0.2 16 0.5 23.25 11.0 4 0.2 1.2 t1 0.3 - 0.6 2.54 +0.4 -0.1 3 6N
H
C
All diminsions in mm.
NOTES 1. MAXIMUM ALIGNMENT DEVIATION BETWEEN LEADS NOT TO BE GREATER THAN 0.2 mm. 2. MAXIMUM NON-CUMULATIVE VARIATION BETWEEN TAPE FEED HOLES SHALL NOT EXCEED 1 mm IN 20 PITCHES. 3. HOLDDOWN TAPE NOT TO EXCEED BEYOND THE EDGE(S) OF CARRIER TAPE AND THERE SHALL BE NO EXPOSURE OF ADHESIVE. 4. NO MORE THAN 3 CONSECUTIVE MISSING COMPONENTS ARE PERMITTED. 5. A TAPE TRAILER, HAVING AT LEAST THREE FEED HOLES ARE REQUIRED AFTER THE LAST COMPONENT. 6. SPLICES SHALL NOT INTERFERE WITH THE SPROCKET FEED HOLES.
Packing Detail
PACKAGE TO-92 Bulk TO-92 T&A STANDARD PACK Details Net Weight/Qty 1K/polybag 200 gm/1K pcs 2K/ammo box 645 gm/2K pcs INNER CARTON BOX Size Qty 3" x 7.5" x 7.5" 5K 12.5" x 8" x 1.8" 2K
Data Sheet
OUTER CARTON BOX Size Qty Gr Wt 17" x 15" x 13.5" 80K 23 kgs 17" x 15" x 13.5" 32K 12.5 kgs
Page 4 of 5
Continental Device India Limited
Notes
BC549, A, B, C BC550, A, B, C TO-92 Plastic Package
Disclaimer
The product information and the selection guides facilitate selection of the CDIL's Discrete Semiconductor Device(s) best suited for application in your product(s) as per your requirement. It is recommended that you completely review our Data Sheet(s) so as to confirm that the Device(s) meet functionality parameters for your application. The information furnished in the Data Sheet and on the CDIL Web Site/CD is believed to be accurate and reliable. CDIL however, does not assume responsibility for inaccuracies or incomplete information. Furthermore, CDIL does not assume liability whatsoever, arising out of the application or use of any CDIL product; neither does it convey any license under its patent rights nor rights of others. These products are not designed for use in life saving/support appliances or systems. CDIL customers selling these products (either as individual Discrete Semiconductor Devices or incorporated in their end products), in any life saving/support appliances or systems or applications do so at their own risk and CDIL will not be responsible for any damages resulting from such sale(s). CDIL strives for continuous improvement and reserves the right to change the specifications of its products without prior notice.
CDIL is a registered Trademark of
Continental Device India Limited
C-120 Naraina Industrial Area, New Delhi 110 028, India. Telephone + 91-11-579 6150 Fax + 91-11-579 9569, 579 5290 www.cdil.com e-mail sales@cdil.com
Continental Device India Limited
Data Sheet Page 5 of 5

▲Up To Search▲

Price & Availability of BC550C

	To Download BC550C Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .